Configuring an Equipment Board

The Equipment Board is used to display information about ACFA integration modules.

To configure the Equipment Board, do the following:

1. Add the board to the layout (see Adding information boards to cells).
   
   

2. If necessary, configure the filters that you want to display on the board by setting the checkbox next to the required option in the drop-down list. Types of filters, options and their description are presented in the table:
   

   Type of filter	Option	Description
   Type	No filter ACFA Controller Loop Reader Sensor Relay Lock Area Group area Fence	Equipment type
   Model	No filter Lock Fence Sensor Reader ACFA integration module	Equipment model
   State	No filter start stop Tamper Obtained Locked Closed AUX trouble Arm Ok Unknown Cracked Opened Normal Unlocked Disarm Disconnected Connected Alarm	Equipment state
   Map	No filter Any Not on map Map	Display equipment on the map

   Note

   If you don’t specify any filters, the board will display all available information about ACFA integration modules.

3. If you want to hide filters on the layout, set the Hide filters checkbox.
4. Click the Save button to save the changes (see Creating and deleting layouts).