Documentation for C-Werk 2.0.

Previous page Record to archive  Wait for timeout Next page

This is the IF condition for running a command (only if the previous steps are completed/not completed in the specified time).

To configure, set up the following parameters:

  1. Set waiting period in HH:MM:SS format for previous action to be performed (1). If 00:00:00 is set, then waiting will last forever.
  2. Specify the action to perform if the previous command was completed within the specified timeout (2). 
  3. Specify the action to perform if the previous action was not completed within the specified timeout (3). If the timeout is 00:00:00, this setting is not applicable.

Attention!

This command does not affect the commands below (outside of) it.

Example: In this macro, replication (1) and the program on the Сlient (5) start at the same time. If replication is completed within 10 minutes (2), an Email message (3) is sent. Otherwise, a voice alert (4) is played.

  • No labels