Documentation for C-Werk 2.0.
Previous page
Next page
To configure the Masks detection tool, do the following:
- Enable the Face mask detection parameter in the Face detection tool settings (see Configuring Face detection).
- In the Number of consecutive mask detections field, set the minimum number of frames in which the detection tool should detect a mask in order to trigger.
Depending on your particular task, set other parameters values according to the table.
Triggering event
Parameters values
Lower face part masking
No mask
Full face masking
No mask of any kind
Absence
Presence
Absence
No medical mask
Absence
Presence
Presence
No balaclava
Presence
Presence
Absence
Any mask present
Presence
Absence
Presence
Medical mask present
Presence
Absence
Absence
Balaclava present
Absence
Absence
Presence
Note
The Other types of masks parameter is not supported in this software version.
- If required, you can set the advanced parameters (see Fine-tuning the Face detection tool).
- Click the Apply button.
Configuring the Mask detection tool is complete.
Overview
Content Tools