This action checks recorded video from a specific camera or group of cameras for the specified period.
To configure this action, do as follows:
Select a camera or a group of cameras to verify their video footage (1).
Attention!
If the start of the macro was triggered by the activation of a sensor or a relay (see Configuring filters for event-driven macros) that is not connected to any camera, you need to select a specific camera here. If you select a group of cameras or a camera that triggered the command, the action will not start.
- Select an archive where you want to check if recorded video is available (2).
- Specify how far back in the past to scan (3). The verification time period covers: [the time of the action start - (minus) the depth of the check; start time of the action].
- Select a reaction if the archive entries are found (4).
- Select a reaction if the archive entries are not found (5).
Note
If E-mail - or SMS-notification is selected as a reaction, then the target cameras will be indicated in the message (if a group of cameras was selected) for which there are no entries in the archive for the specified period.