Configuring Masks Detection

To configure the Masks detection tool, do the following:

1. Enable the Face mask detection parameter in the Face detection tool settings (see Configuring Face detection).
2. In the Number of consecutive mask detections field, set the minimum number of frames in which the detection tool should detect a mask in order to trigger.
   

3. Depending on your particular task, set other parameters values according to the table.

   Triggering event	Parameters values
   	Lower face part masking	No mask	Full face masking
   No mask of any kind	Absence	Presence	Absence
   No medical mask	Absence	Presence	Presence
   No balaclava	Presence	Presence	Absence
   Any mask present	Presence	Absence	Presence
   Medical mask present	Presence	Absence	Absence
   Balaclava present	Absence	Absence	Presence

   Note

   The Other types of masks parameter is not supported in this software version.

4. If required, you can set the advanced parameters (see Fine-tuning the Face detection tool).
5. Click the Apply button.

Configuring the Mask detection tool is complete.