You can check the triggering of detection tools in the Detection Tools tab.
To use this option you must perform the following steps:
In the Detection Tools list, highlight the detection tool object whose triggering you need to check.
Attention!
The Detection Tool object should be enabled and configured
- Produce an event whose occurrence should trigger the detection tool: motion in the frame, turning the video camera, providing sound to an audio device, etc.
- If the detection tool is configured correctly, video image frames from the video camera corresponding to the detection tool will be displayed on the trigger ribbon with the time they were received indicated.
VMS checks the on / off status of detection tools when they triggered and stopped. Not applicable to detection of: quality loss, position change, disappearance of an object, motion stop and ANPR.
After the end of triggering, you get the Completed message.
Checking the triggering of a detection tool is now complete.