To control a PTZ camera, you can use both step buttons (discrete telemetry mode) and the virtual joystick (the camera must support continuous telemetry), if the camera supports both modes.
To select, click the 
and 
buttons.
Otherwise, only one of the modes may be used.
Set the sensitivity level of telemetry step buttons by selecting a value from 1 to 10.
Virtual joysticks are controlled as follows:
- Click and hold down the left mouse button in the central (blue) portion of the joystick.
- Drag the joystick in the necessary direction.
Note
You can also move the joystick by clicking and holding the left mouse button outside of the joystick border.
The turn speed depends on the tilt of the joystick: the greater the tilt, the higher the speed.
Note
If you rotate a camera view / viewing tile 180 ° , you will have PTZ controls inverted.