Documentation for C-Werk 2.0.
Previous page Next page
The detection tool will trigger if an object stops and remains idle for a specified time period.
Note
The object doesn't have to be completely idle, minor jitter is permitted.
To set a specified time period, you must perform the following steps:
- In the Detection Tools list, highlight a Stop in area object (1).
Set the idle period duration for triggering the tool (2). This value should fall into the range of [0, 3600].
Attention!
Set this parameter to a value lower than the Time of object in DB in Object tracker settings (see Setting general parameters of Tracker-based Scene Analytics detection tools).
Attention!
If a detection tools runs on VMD metadata, the Stop in area duration should be set to 0. Otherwise, the detection tools will not work.
- Click the Apply button.
Overview
Content Tools