Documentation for C-Werk 2.0.

Previous page Temperature screening protocol  Configuring Face Detection and Temperature Control Next page

Attention!

Install MX-V5.2.6.7 (2020-06-16) or later firmware.

For detailed configuration via the web interface, refer to manufacturer's instructions.

Before starting C-Werk, please configure the camera via the web interface:

  1. Proceed to admin menu (1), and select Temperatures (2).
  2. Measure environmental temperature.
  3. Select Setup Menu (1), and then Thermal Sensor Settings (2).
  4. Select the Temperature Compensation checkbox (1).
  5. Enter the environmental temperature value (2, see point 2).
  6. Specify the Value Range and Thermal Range parameters as shown on the screenshot.
  7. To caption video with temperature readings, select Display Mode (Right) (1), and then Picture in Picture (2) checkboxes.
  8. Save the settings.
  • No labels