Changing the network settings of a camera via the IP Finder Utility

To change the network settings of a camera, perform the following:

1. Select the desired camera from the list (1).

   Note

   You may select multiple cameras. To do this, select the checkboxes alongside their respective cameras.

2. Select the DHCP check box (2) if you want to use the dynamic host configuration protocol.

3. In the IP Address (3) field, enter the IP address of the camera.

4. In the Mask (4) field, enter the subnet mask of the camera's IP address.

5. Enter the gateway address into the Gateway (5) field.

6. In the SDK port (6) field, enter the SDK port number.

7. In the HTTP port (7) field, enter the HTTP port number.

8. Click Update (8) to apply the settings.
   

   If the settings are applied correctly, a dialog box will appear containing the "Successfully updated" message.
   

That is how we change the network settings of cameras via the IP Finder Utility.