Previous page Creating the SMS Object  Checking SMS notifications Next page

To configure an SMS object, you must perform the following steps:

  1. In the list of devices, highlight the SMS object which needs to be configured (1).
  2. Activate the SMS object (2) by selecting Yes in the Enable list.
  3. In the Name field (3) enter the desired name of the SMS object.
  4. In the To field (4), enter the cellular telephone number, in international format (+<country code>хххххххххx), to which messages will be sent.
  5. In the SerialPort settings group (5), indicate the port settings used to connect to the GSM modem by which SMS messages will be sent:
    1. If you need to use a DTR control signal, select Yes from the DTR list.
    2. In the Bits field, enter the number of bits in the byte of a data packet.
    3. In the Stop bits length field, enter the number of bits in the stop bit of a data packet.
    4. If you need to use a parity check when transmitting data, select the desired method of parity check from the Parity list.
    5. From the Port list, select the serial port used to connect to the GSM modem.
    6. If hardware control of the serial port data protocol is enabled (see step 5.8) and you need to use an RTS signal, select Yes from the RTS signal list.
    7. Select the speed for data transmission via the GSM modem from the Baud rate list.
    8. If you need to control the serial port data protocol, select the desired method of control from the Handshaking list: hardware (RTS/STS), software (XOn/XOff), or alternating.
  6. Click the Apply button.

Configuration of the SMS object is now complete.