If you are using a fisheye camera or video camera with a panomorph lens, configure the following settings of the Video camera object, in the Panomorph settings group:
- To activate panoramic view, in the Activate list (1) , select Yes.
In the Video camera position list (2), select the mount of the video camera.
Important!
Some system features and functions depend on the chosen position of the video camera: digital zoom, display of video in the surveillance sector on the map, and immersive mode
If it is a fisheye camera, select the Standard fisheye lens lens type (3).If it is a video camera with a panomorph lens, select the corresponding type (3).
Note
The types of device lenses certified by ImmerVision are listed in the document.
If it is a video camera with an Immervision lens, select the appropriate display mode (4): 360о panorama with virtual telemetry (PTZ) or 180о panorama (Perimeter).
A typical fisheye lens with standard settings produces a skewed image in the upper part of the screen. If this is the case, enable the Fit to frame option (5).
Important!
If you have multiple streams from a camera, you need to calibrate each stream. To do this, before applying the settings, switch to the required stream tab in the viewing tile (see The Video Camera Object).
Important!
Video is calibrated every time you change any parameters in the Panomorph group.
Manual calibration is also available. To do this:
Disable Fit to frame , select No in the Enable list and click the Apply button.
Select Yes in the Enable list.
- Configure the video area (circle). Left-click any point inside the circle and move the mouse pointer. To change the diameter of the circle, do as follows: click an anchor point
and move the mouse pointer.
- Click the Apply button.
After applying the settings, the area outside the circle will be cut.
Configuration of the fisheye camera is complete.