Documentation for C-Werk 2.0.

Previous page Configuring information board templates  Configuring an Alarm Board Next page

Switching to layout editing mode

The Equipment Board is used to display information about ACFA integration modules.

To configure the Equipment Board, do the following:

  1. Add the board to the layout (see Adding information boards to cells).

  2. If necessary, configure the filters that you want to display on the board by setting the checkbox next to the required option in the drop-down list. Types of filters, options and their description are presented in the table:

    Type of filterOptionDescription
    Type
    • No filter
    • ACFA
    • Controller
    • Loop
    • Reader
    • Sensor
    • Relay
    • Lock
    • Area
    • Group area
    • Fence
    		Equipment type 
    Model
    • No filter
    • Lock
    • Fence
    • Sensor
    • Reader
    • ACFA integration module
    		Equipment model
    State
    • No filter
    • start
    • stop
    • Tamper
    • Obtained
    • Locked
    • Closed
    • AUX trouble
    • Arm
    • Ok
    • Unknown
    • Cracked
    • Opened
    • Normal
    • Unlocked
    • Disarm
    • Disconnected
    • Connected
    • Alarm
    		Equipment state
    Map
    • No filter
    • Any
    • Not on map
    • Map
    		Display equipment on the map

    Note

    If you don’t specify any filters, the board will display all available information about ACFA integration modules.

  3. If you want to hide filters on the layout, set the Hide filters checkbox.
  4. Click the Save button to save the changes (see Creating and deleting layouts).
  • No labels