Documentation for C-Werk 2.0.

Previous page Types of Devices Used  Configuring IP Devices in Windows Next page

To work with IP devices, you need to connect the C-Werk server to the local network where the required IP devices are enabled.

To ensure support for IP devices on an external network:

  • The IP devices must have an external static IP address.
  • The necessary ports on the network equipment must be opened.

Attention!

If these requirements are met, IP devices should be properly handled. However, correct functioning is not guaranteed.

Based on the video signal coming in from the IP device, an assessment is made of the guarded location and the system responds to events registered for that location. The content and quality of the obtained video information depends on how the IP device is installed and configured. There are a number of rules that must be followed to obtain a high-quality video signal. In particular, high-quality peripheral equipment (hubs/routers) must be used; we advise against use of Home and Office-class devices, which are not intended for use in such security systems.

Note

IP devices connected to such equipment will transmit a video stream with an unacceptably long delay (from 1.5 to 3 seconds per frame)

Detailed information about creating a local network and connecting IP equipment to it is presented in the corresponding reference documents.

  • No labels